2002 Ford Explorer Heat Blend Door Actuator This is a 02 ford explorer that has a broken and worn heat blend door actuator. the labor at a dealership with parts is approx $700 800 if you take it to th. What's up everyone! today we replace the blend door actuator in the explorer to fix the no heat issue, and get rid of the awful clicking noise when you try t.
How To Replace Temperature Blend Door Actuator 95 02 Ford Explorer Ford Explorer Car 97 sport 4x4. may 7, 2007. #9. dorman makes a replacement blend door ($10). just remove the evaporator housing in the engine compartment and pull the old blenddoor out and put the new and improved one in. takes about 2 hours if you take your time. 1997 ford explorer sport: over 600,000 miles and still going. This video is how to fix no heat, blend door issues 02 10 ford explorer. do you have a clicking noise behind the dash and have no heat or a c?amazon affiliat. They are right next to each other. the heater blend actuator is the one furthest toward the rear of the vehicle. they are behind the rear heater enclosure, sandwiched between the heater enclosure and the steel body quarterpanel. (1) remove all the interior trim covering the drivers side rear interior quarterpanel. In my case, both my blend door was broken, and its actuator was shot (click, click, click went the stripped gears). finally, the moment you’ve all been waiting for; removal of the old blend door. take a good look at the bottom of the plenum. the circular area which sticks down is where the bottom of the blend door shaft sits.
No Heat 2002 2010 Ford Explorer Clicking Temp Blend Actuator Removal Youtube They are right next to each other. the heater blend actuator is the one furthest toward the rear of the vehicle. they are behind the rear heater enclosure, sandwiched between the heater enclosure and the steel body quarterpanel. (1) remove all the interior trim covering the drivers side rear interior quarterpanel. In my case, both my blend door was broken, and its actuator was shot (click, click, click went the stripped gears). finally, the moment you’ve all been waiting for; removal of the old blend door. take a good look at the bottom of the plenum. the circular area which sticks down is where the bottom of the blend door shaft sits. 1:28. unplug your actuator by pushing on the little tab. step 3 :remove actuator. 2:14. use your wrench to remove the bolts and lift the actuator out. step 4 :test actuator. 3:23. with the key on, rotate your temperature knob and the actuator should rotate in response. step 5 :plug in actuator. This video will explain how to access and repair the heat ac blend door on a ford explorer or mercury mountaineer. if your ac or heat is stuck on and the ble.
Comments are closed.